Interlogix UltraView IP PTZ 36X Camera Quick Start: Installing a camera

Installing a camera

1. Prepare the mounting surface and install the camera bracket.

2. Unscrew the bubble from the camera and remove the protective

tape from the PTZ module.

3. Press the two tabs on either side of the PTZ module and remove it

from the camera housing. Ensure the module cables still exit from

the cable entry hole in the top of the housing.

Note: If alarm and audio input/output relays are to be used,

connect them to the PCB of the module and route their cables

through the cable entry hole on tom of the housing. See the user

manual for further information on the alarm connections.

4. Install the housing.

Pendant-mount camera:

Attach the camera housing to the bracket using the screws

enclosed with the bracket.

Flush-mount camera:

Adjust the height of the two housing tabs by turning the screw on

which they are attached. The distance (h) of the tabs from the

housing ring must be greater than the thickness of the ceiling.

Housing tab

Screw

EN 2 UltraView IP PTZ 36X Camera

Make sure the housing tab is closed and then PUSH the housing

into the pass-through hole. Hold the housing and fix it by screwing

the housing tabs down to the mounting surface

5. Insert the PTZ module into the housing: