Zelmer 619: FILTERS REPLACEMENT ECOLOGY
FILTERS REPLACEMENT ECOLOGY: Zelmer 619
Table of contents
- 57
- 61
- IMPORTANT SAFETY INSTRUCTIONS TECHNICAL DATA
- 85
- 86
- A – FOR VACUUMING WITH PAPER BAG WITHOUT WATER. B – FOR VACUUMING WITH PAPER BAG WITH 1.5 L OF WATER AS ADDITIONAL FILTER. C – FOR VACUUMING WITHOUT PAPER BAG, DIRECTLY TO THE FILTER CUP USING “FIZELINA” FILTRATION PAD, OR WITHOUT IT.
- ATTENTION!!! In case of difficulties in a/m elements connection lubricate the sealing with i.e. ATTENTION!!! Be careful during pulling the cord out, the yellow mark on the ATTENTION!!! The vacuum cleaner is equipped with a float, which shall In such situation: ATTENTION!!! The float can also operate during sudden movements, sharp pulling, hitting, or crossing the doorsteps.
- 89
- CLEANING CARPETS
- PLAIN FLOORS CLEANING AFTER OPERATION
- FILTERS REPLACEMENT ECOLOGY
92
−
Remove the water filter from the tank.
−
Remove the foam filter from the water filter and rinse it under running water
from the inside of the foam.
ATTENTION!!! Do not wash the filtration foam in hand by wringing it or in
washing machines Avoid squashing, stretching or
deformation. Dry after washing in ambient temperature
straightened or hanged on the handle.
Never dry the foam on the heaters, radiators, ovens, etc.
−
Pour the dirty water out through the inlet for hose assembling.
−
Clean the tank and water filter thoroughly, change the water some times.
−
After washing clean thoroughly all the elements of accessories used during this
process (hose, tubes, accessories).
Leaving the a/m parts unclean or not exactly cleaned can cause the loss of
filtration abilities of the pads and foam and enhance bacteria and mites development.
−
Dry all the cleaned parts thoroughly.
ATTENTION!!! Never assemble the vacuum cleaner before drying cleaned parts.
−
Insert the water filter, place the tank on the base and close the top lid.
FILTERS REPLACEMENT
Air-inlet and air-outlet filters get dirty during operation. It is recommended to flush air-inlet filter to
provide proper operation. Very dirty or damaged air-inlet filter must be replaced with a new one.
Air inlet filter replacing
−
Open the vacuum cleaner lid and place it in vertical position.
−
Catch the upper edge of the filter grid (from the front) and pull it slightly in your
direction until it gets out of the hooks.
−
Turn the frame, remove the filter, rinse it under running water, press slightly, dry
and replace (or replace with a new one).
−
Place the new filter thoroughly, so that after closing the frame, its edges were
tightly pressing the filter edge.
−
Close the filter frame.
Air-outlet filter
The air-outlet filter should be exchanged after about 30 operational hours (6 months),
or earlier in case of strong dirtiness.
−
Press the cocker and open the outlet cover.
−
Exchange the filter insert:
Type 619.5*E – fig.
A;
Type 619.5*S – fig.
B
Electrostatic filter
Cassette with HEPA filter
−
Insert the filter thoroughly (fig.
A
), so
that after closing the frame, its edges
were tightly pressing the filter edge.
If any water occurs at air-outlet filter, it means that there is some foam inside the front tank,
which condenses at the air-outlet filter, after getting through the turbine. In order to avoid such
phenomenon it is required to add foam neutralizing agent recommended by ZELMER S.A., and
switch on for some minutes (without front tank) in order to dry the suction system.
Air-outlet filter should be always replaced with a brand- new, original one.
ECOLOGY
At the end the product’s useful life, please dispose of it at appropriate collection points
provided in your country.
619-195
B
A
