GIGASET COMMUNICATIONS GMBH 5015: инструкция

gase

en-

r-ru-

r

-

-

-

-

.

m

.

.

1

EN

Gigaset 5015 Quick Guide

Display symbols

P In setting mode

1211109

1

‡ Shift key pressed

--- Ready for use

y Microphone off

o Entry mark when setting (e.g. volume)

u

Recall key pressed

P

Pause

z

No memory content

---- PIN entry

zzzz

Telephone locked

0

–

9

Phone number

With tone dialling:

8

n

– * key pressed

7

6

-

– # key pressed

With additional services from public network providers:

ë Call waiting

™ Call forwarding immediately

45

23

˜ Call forwarding on no reply

Keys

— Call forwarding when busy

1 Repertory keys

2 Last number redial key

Safety precautions

3 Recall key

When installing, connecting and operating the telephone,

4Mute key

always observe the following precautions:

5Shift key

◆ Only use the plugs and leads supplied.

6Quiet key

◆ Only connect the connecting lead to the socket/jack

7 Loudspeaker key (handsfree)

provided for that purpose.

8Loud key

◆ Only connect approved accessories.

9Set key

◆ Arrange the connecting lead where it will not cause

10 Lock key

accidents.

11 Reset key (call duration)

◆ Position the telephone on a non-slip surface.

12 Pause key

◆ For your safety and protection, the telephone must not

be used in bath or shower rooms (wet locations).

The telephone is not splash proof.

◆ Never expose the telephone to sources of heat, direct

sunlight or other electrical devices.

◆ Protect your telephone from moisture, dust, corrosive

liquids and vapours.

◆ Never open up the telephone yourself.

◆ Do not touch the plug contact with pointed or metallic

objects.

◆ Do not carry the telephone by the leads.

◆ If you give your Gigaset 5015 to someone else, make

sure you also give them the user guide.

gase

en-

r-ru-

r

-

-

-

-

.

m

.

.

2

EN

All electrical and electronic equipment must be disposed of

separately from general household waste using the sites

designated by local authorities.

If a product displays this symbol of a crossed-out rubbish bin,

the product is subject to European Directive 2002/96/EC.

The appropriate disposal and separate collection of used equipment

serve to prevent potential harm to the environment and to health.

They are a precondition for the re-use and recycling of used electrical

and electronic equipment.

For further information on disposing of your used equipment, please

contact your local authority or your refuse collection service.

Preparing the telephone for use

Recommended installation of telephone

◆ Do not expose the telephone to direct sunlight or other

sources of heat.

◆ Operate at temperatures between +5°C and +40°C.

◆ Maintain a distance of at least one metre between the

telephone and radio equipment, e.g. wireless

telephones, wireless pagers or TV sets. Otherwise,

telephone communication could be impaired.

◆ Do not install the telephone in dusty areas as this can

Making calls

shorten the service life of the telephone.

◆ To clean, wipe with a moist or antistatic cloth only, never

Dialling a number

with a dry cloth (risk of electrostatic charging and

co Lift handset, dial number.

discharge) or harsh cleaning agent.

Any digits after the 20th digit are moved from right to left in

◆ Furniture lacquer and polish can be damaged by contact

the display. The Pause key

< can be used to insert pauses

with parts of the unit (e.g. device feet).

when dialling, starting from the 2nd digit.

Connecting

Last number redial (one of the last 5 call numbers)

Insert the short end of the coiled handset cord in the socket

The last 5 different call numbers dialed are automatically

provided in the handset and the long end in the socket

saved (max. 32 digits each).

marked with an

a on the underside of the device. Plug the

phone cord into the outlet on the wall and the other end

c Lift handset (or press the Loudspeaker key L

into the socket marked with a

Y on the underside of the

until the dialling tone is audible).

device. Then your telephone is ready to use.

;...; Press the Redial key repeatedly until the

required call number appears with the place

number (1...5 on the left).

o Enter the place number (1...5).

The relevant call number is redialed.

Dialling using the repertory keys

c Lift handset (or press the Loudspeaker key L

until the dialling tone is audible). (If necessary,

press

= for a 2nd level repertory key).

: Press repertory key.

gase

en-

r-ru-

r

-

-

-

-

.

m

.

.

3

EN

Saving numbers

Adjusting the telephone

Different telephone settings must be completed with the

Adjusting the ringer volume

Set key

? so that they are available permanently.

The volume of the ringer can be set to one of 7 levels and

In order to cancel without saving, e. g. after an incorrect

can also be deactivated completely (default setting: level 7,

entry, replace the handset instead of pressing

? at the

highest level) or deactivated completely. When the ringer is

end. The original setting is then retained.

deactivated an incoming call is notified in the display only.

Saving with notebook function

◆ To adjust when the telephone is idle:

You can also save phone numbers during a conversation

with the notebook function.

c?5 Lift handset, initiate function.

H...I Adjust the volume with the Loud/Quiet key.

Saving repertory numbers

?a Press the Set key. Replace handset.

You can save up to 20 phone numbers (or even functions,

◆ To adjust while the telephone is ringing:

see page 6) on both levels of the repertory keys.

Press

H...I before lifting the handset.

c? Lift handset, press the Set key. (For 2nd mem-

The last value set is saved.

ory level, also press

=.)

: Press the repertory key under which you want

Setting the ringer frequency

to save the repertory number.

The frequency (speed) of the ringer can be set to one of

A number that has already been saved is

three levels (default setting: level 3).

shown in the display. If the memory for this

c?6 Lift handset, initiate function.

repertory key is empty,

z

appears in the display

1...3 Press one of the keys 1...3:

o Enter the number to be saved (up to 32 digits).

1: highest frequency; 3: lowest frequency.

or ...

?a Press the Set key. Replace handset.

Saving from the redial list:

Setting the ringtone

;...; Press the Redial key repeatedly until the

desired phone number is displayed on the

Ten different ringtones can be set for the ringer (default

screen.

setting: ringtone 0).

?a Press the Set key. Replace handset.

c?7 Lift handset, initiate function.

Pressing

< allows you to save pauses (not at the 1st digit).

0...9 Press one of the keys 0 ... 9

After the 20th digit, any following digits are moved from

?a Press the Set key. Replace handset.

right to left in the display.

Setting the handset volume

Delete all repertory numbers

The volume on the handset can be set to one of 3 levels and

c?1251

saved (default setting: level 1).

Lift handset, initiate function.

c?9 Lift handset, initiate function.

?a Press the Set key. Replace handset.

H...I Adjust the volume with the Loud/Quiet key.

?a Press the Set key. Replace handset.

Mute

You can deactivate the telephone's handset and

microphone. Then the other party can no longer hear you.

J During a call: Press the Mute key

Activate: Press the key again.