Beko WKD 75100: 7 Cleaning and care
7 Cleaning and care: Beko WKD 75100
25
EN
7 Cleaning and care
Detergent drawer
Remove any powder residue buildup in
thedrawer.Todothis;
1. Pressthedottedpointonthe
siphon in the softener compartment
and pull towards you until the
compartment is removed from the
machine.
Outer cabinet and control
panel
Whennecessary:
• Wipetheexteriorpanelsofyour
machine with soapy water or mild
detergent. Dry it with a soft cloth.
• Useonlyasoftanddampclothto
C If more than a normal amount of
clean the control panel.
water and softener mixture starts to
C Never use a sponge or scrubbing
gather in the softener compartment,
material. These will damage the
the siphon must be cleaned.
painted and plastic parts.
2. Wash the dispenser drawer
and the siphon with plenty of
Inlet water filters
lukewarm water in a washbasin.
There is a filter at the end of each
Wear protective gloves or use an
water intake valve at the back side of
appropriate brush to avoid touching
the machine and also at the end of
the residues in the drawer when
each water intake hose where they
cleaning.
are connected to the tap. These filters
3. Replace the drawer into its housing
prevent the foreign substances and dirt
after cleaning. Check if the siphon
in the water to enter into the machine.
is in its original location.
Filters should be cleaned as they get
dirty.
The door and the drum
• Closethetaps.
Aftereachwash:
• Checkifthereareanyforeign
substances in the drum.
• Opentheholeinthebellowwiththe
aid of a toothpick if it is clogged.
C Foreign metal substances in your
machine can cause rust stains. In
suchcases:
Clean the drum with a stainless steel
cleaning agent. Never use steel wool
or wire wool.
26
EN
• Removethenutsofthewaterintake
hoses to clean the surfaces of the
filters on the water intake valves with
an appropriate brush.
• Ifthefiltersareverydirty,youcan
pull them out by means of pliers and
clean them.
• Takeoutthefiltersontheflat
pull the piece out towards yourself.
ends of the water intake hoses
If it is composed of one piece, hold it
together with the gaskets and clean
from both sides and open it by pulling
thoroughly under streaming water.
• Replacethegasketsandfilters
carefully and tighten the hose nuts
by hand.
Draining any remaining water
and cleaning the pump filter
Filter system in your machine prevents
solid items such as buttons, coins and
fabric fibers clogging the pump propeller
out.
during discharging of the washing
water. Thus, a good water discharger is
3- An emergency drain hose is supplied
achieved and the pump life is extended.
withsomeofourmodels.Othersarenot
• Ifyourmachinefailstodrainthe
supplied with this item.
water, the pump filter may be
clogged.Youmayhavetoclean
If your product is supplied with an
it every 2 years or whenever it is
emergency drain hose, do the following
blocked plugged. Water must be
drained off to clean the pump filter.
In addition, water may have to be
drained off completely in the following
cases:
• beforetransportingthemachine
(e.g.whenmovinghouse)
• whenthereisthedangeroffrost
In order to clean the dirty filter and
dischargethewater;
1- Disconnect or unplug the machine
from the power supply.
asshowninthefigurebelow:
A There may be water at 90°C in the
• Pulloutthepumpoutlethosefrom
machine. Therefore, the filter must
its housing.
be cleaned only after the inside
• Placealargecontainerattheendof
water is cooled down to avoid
the hose. Drain the water off into the
hazard of scalding.
container by pulling out the plug at
the end of the hose. If the amount
2-Openthefiltercap.Thefiltercap
of water to be drained off is greater
may be composed of one or two pieces
than the volume of the container,
according to the model of your machine.
replace the plug, pour the water out,
If it is composed of two pieces, press
then resume the draining process.
the tab on the filter cap downwards and
• Afterdrainingprocessiscompleted,
27
EN
replace the plug into the end of the
hose and fit the hose back into its
place.
If your product is not supplied with an
emergency drain hose, do the following
asshowninthefigurebelow:
• Placealargecontainerinfrontofthe
filter to receive water flowing from
the filter.
• Loosenpumpfilter(anticlockwise)
until water starts to flow out of it.
Direct the flowing water into the
container you have placed in front
ofthefilter.Youcanuseapieceof
cloth to absorb any spilled water.
• Whenthereisnowaterleft,turnthe
pump filter until it is completely loose
and remove it.
• Cleananyresiduesinsidethefilter
as well as fibers, if any, around the
propeller region.
• Ifyourproducthasawaterjet
feature, be sure to fit the filter into
its housing in the pump. Never force
the filter while replacing it into its
housing. Fit the filter fully into its
housing;otherwise,watermayleak
from the filter cap.
4- Close the filter cap.
Close the two-piece filter cap of your
product by pushing the tab on it.
Close the one-piece filter cap of your
product by fitting the tabs on the bottom
into their positions and pushing the
upper part of it.
Оглавление
- СОДЕРЖАНИЕ
- 1 Ваша стиральная машина
- 2 Предупреждения
- 3 Установка
- 4 Подготовка к стирке
- 5 Выбор программы и эксплуатация машины
- 6 Краткая инструкция для повседневного
- 7 Чистка и уход
- 8 Устранение неисправностей
- Please read this manual first!
- TABLE OF CONTENTS
- 1 Your Washing Machine
- 2 Warnings
- 3 Installation
- 4 Initial preparations for washing
- 5 Selecting a program and operating your machine
- 6 Quick instructions for daily use
- 7 Cleaning and care
- 8 Troubleshooting
- Гарантийный талон серия RUS
