Ariete Bagless Vacuum Cleaner 2798: IMPORTANT SAFEGUARDS

EN

- 7 -

IMPORTANT SAFEGUARDS

READ THESE INSTRUCTIONS BEFORE USING THE APPLIANCE.

A few precautions are necessary while using the appliance:

Always make sure that the mains power voltage is the same as that listed on the appliance rating 

1. 

plate and that the mains system is suitable for use with the appliance power.  

This appliance conforms to the 2006/95/CE and EMC 2004/108/CE directives.

2. 

The appliance may only be used for its intended purpose, which is for vacuuming dust from 

3. 

surfaces within the home. Any other use is to be considered improper and therefore, danger-

ous. The manufacturer may not be held liable for any damages caused by improper, incorrect or 

unreasonable use.

Do not use to vacuum hot ash, large pieces of glass, rubble, sharp or pointed items or liquids. 

4. 

To prevent dangerous overheating, always unwind the power cord fully and unplug the appliance 

5. 

from the mains when the appliance is not in use.

Only plug the appliance into an AC socket.

6. 

The appliance must not be used without 

fi

lters or if the 

fi

lters are damaged or broken.

7. 

Never use the appliance on wet surfaces.

8. 

Never suck up liquids.

9. 

NEVER PLACE THE APPLIANCE IN WATER OR OTHER LIQUIDS.

10. 

Do not touch the appliance when hands or feet are wet or moist.

11. 

Never use the appliance with bare feet.

12. 

Do not leave the appliance exposed to the elements (rain, sun, etc.).

13. 

Do not keep the appliance in proximity to heat sources (e.g., radiator). 

14. 

Always disconnect the plug from the mains power before cleaning the appliance or changing the 

15. 

fi

lters.

This appliance is not intended for use by persons (including children) with reduced physical, sen-

16. 

sory or mental capabilities, or lack of experience and knowledge, unless they have been given 

supervision or instruction concerning use of the appliance by a person responsible for their safety. 

Children should be supervised to ensure that they do not play with the appliance.

17. 

Never pull on the power cord to unplug the appliance from the mains power. 

18. 

Make sure that the power cord does not come into contact with sharp or hot surfaces.

19. 

Never use the appliance if the power cord is damaged.

20. 

If the cord is damaged, it must be replaced by the Manufacturer, by an Authorised Technical As-

21. 

sistance Centre or in any case, by a similarly quali

fi

ed person, in order to prevent any risks.

Always switch on the appliance with the power regulator set to minimum.

22. 

Unplug the appliance from the mains electricity after each use.

23. 

In the event that you decide to dispose of the appliance, we advise you to make it inoperative 

24. 

by cutting off the power cord.  We also recommend that any parts that could be dangerous be 

rendered harmless, especially for children, who may play with the appliance or its parts.

Packaging must never be left within the reach of children since it is potentially dangerous.

25. 

DO NOT THROW AWAY 

THESE INSTRUCTIONS

EN

- 8 -

DESCRIPTION OF THE APPLIANCE (Fig. 1)

VACUUM CLEANER ASSEMBLY

Insert the hose into the suction opening, pressing it down until it slots into place.  To remove the hose, 

press the two release buttons together and pull it out (FIG. 2).

CAUTION

: Before 

fi

tting or removing attachments, always be sure to unplug the appliance from the 

mains power.

ATTACHMENTS

Telescopic tube (R)

Insert the extension tube onto the handgrip then 

fi

t the required attachment. Once the attachment has 

been inserted, it is possible to extend the telescopic tube to the required length using the lever (FIG. 

3).  Release the lever to secure the tube at the required length.

Floor brush (M)

Suitable for cleaning any type of surface. Use the device on the top part to:

-   retract the bristles when cleaning carpets or rugs;

-   lower the bristles for smooth 

fl

ooring, such as PVC, parquet or tiles.

Crevice nozzle with brush (I)

This suction device is ideal for cleaning between the folds on fabrics, joints, corners or niches that 

are impossible to reach using the 

fl

oor cleaning device.  This attachment can also be 

fi

tted directly to 

the handle (Q).

Small nozzle (L)

Useful for removing dust from books or other delicate items such as picture frames, etc.

It is also suitable for cleaning upholstered furniture, mattresses, soft furnishings, etc.  and can also be 

fi

tted directly to the hand grip (Q).

A  Suction device coupling

B Dust 

container

C  Dust container handle

D  Foot-operated cord rewinder button

E  Top carry handle

F  Dust container removal button

G  Foot-operated on/off switch

H  HEPA filter compartment

I  Crevice nozzle with brush

L Small 

nozzle

M Floor 

brush

N  Hard floors/carpet selector

O Release 

buttons

P Suction 

control

Q Hand 

grip

R Telescopic 

tube

S Flexible 

hose

EN

- 9 -

USING THE APPLIANCE

CAUTION

: Before using the vacuum cleaner, remove all large or sharp objects from the 

fl

oor to avoid 

any possible damage to the cleaner itself.

First of all, before using this appliance, unwind the power cord completely and plug the appliance into 

the mains socket.

To switch on the appliance, press the foot switch (G) on the vacuum cleaner. 

IMPORTANT

: In some cases, the appliance may “whistle” when switched on.  This is not a fault and 

the noise will go away with time. 

Secondary air valve (P)

The secondary air valve (P) is on the hand grip (Q) and it is used to regulate suction power (FIG. 4). 

The larger the valve opening, the lower the suction power and vice versa.

-  To open the valve, push the lever upwards and to close it, push the lever downwards.

Valve adjustment depends on the type of surface:

-  Minimum suction power for curtains and delicate materials.

-  Medium suction power for cushions, mattresses and carpets.

-  Maximum suction power for tiled, wood or other resistant 

fl

oor surfaces that are heavily soiled.

WARNING

: Switch off the vacuum cleaner immediately if the air inlets, brushes or telescopic tube be-

come blocked.  Remove the cause of the blockage before switching the vacuum cleaner on again.

After using the vacuum cleaner

After use, switch off the vacuum cleaner using the pedal switch (G), unplug it from the mains power 

and wind in the cord by pressing the cord winder pedal (D) on the appliance.  The cord will wind inside 

the appliance container.

WARNING

: While winding the power cord, guide it with one hand so as to prevent injury and take care 

in the presence of children or pets.

Put away the appliance, inserting the 

fl

oor brush (M) into the hook on the back of the cleaner (FIG. 

5), if necessary.

Carrying the vacuum cleaner

This vacuum cleaner has a carry handle (E).

CLEANING AND MAINTENANCE

WARNING

: Before carrying out any cleaning or maintenance operation, switch off the appliance and 

unplug it from the mains power.

The vacuumed dirt goes into the dust container (B).  The air is cleaned by a permanent and wash-

able 

fi

lter, inside the container itself (B) and by a motor protection 

fi

lter in the special compartment 

(H).

WARNING

: Never use the vacuum cleaner if any 

fi

lter is missing or damaged.  Any dust cleaned up 

will enter the appliance and damage the motor.

WARNING

: Clean the 

fi

lters regularly or in any case, whenever the suction power seems to be re-

duced.

EN

- 10 -

Emptying the dust container (B)

The container is clear, which means it is easily possible to see when it needs to be emptied.

-  Press the release button and at the same time, remove the dust container (B) using the relevant 

handle (C) (FIG. 6).

-  Empty the dust from the container (B) by opening the lid by pressing down on the release button 

(FIG. 7).

CAUTION

: Only wash the 

fi

lter using clean water; never use soap or detergent.

-   To clean the container (B) thoroughly, it needs to be taken out and disassembled, as follows:

-  remove the lid by turning it anticlockwise (FIG. 8);

- pull 

the 

fi

lter upwards and out (FIG. 9).

IMPORTANT

: Wash the 

fi

lter with clean water only.  Do not use soap or detergents.

This operation needs to be carried out every 6 months or whenever the vacuum cleaner suction 

power is visibly reduced.

-  The container needs to be reassembled before it can be used again (B).

-  insert the filter inside the container (B);

-  put the lid back on the container (B), moving the triangle mark on the lid so that it is in line with the 

symbol “

” on the container and turning it clockwise until it completely locks into place (FIG. 10).

-  Refit the reassembled dust container (B) onto the appliance, pressing down until it clicks into place 

(FIG. 11).

Cleaning the HEPA exhaust 

fi

lter

This 

fi

lter cleans the air a 

fi

nal time before it leaves the vacuum cleaner. The motor 

fi

lter and its special 

covering need to be cleaned on a regular basis.

-  Turn the cover on the side of the appliance anticlockwise and remove it (FIG. 12).

-  Take out the 

fi

lter and rinse it under running water (FIG. 13). Leave it to dry thoroughly.

- Re

fi

t the 

fi

lter and lid, turning it so that the triangle mark is lined up with the “

” symbol on the 

appliance. Turn it anticlockwise to lock it into place (FIG. 14).

WARNING

: Only wash the 

fi

lter in clean water, without using soap or detergents.

WARNING

: This operation is necessary at least once every 6 months or in any case, when suction 

power is notably reduced.

Cleaning the vacuum cleaner

The casing, dust container and 

fi

lter seats can be wiped with a damp cloth if necessary. No liquid must 

enter the vacuum cleaner in the process. Never use heavy-duty cleaning substances (stain removers, 

thinners) because they can corrode the plastic surfaces. Only put the plug back into the mains socket 

when you are sure that all parts are thoroughly dry.

IMPORTANT

: Do not lubricate or oil any rotating parts, since this could cause dirt and 

fl

uff to stick 

even further.

EN

- 11 -

TROUBLESHOOTING

Thermal cutout switch

The vacuum cleaner is equipped with a thermal cutout switch to protect it in the event that the motor 

overheats. If the vacuum cleaner suddenly switches off by itself, proceed as follows:

-   Switch off the vacuum cleaner and unplug it from the mains power.

-   Look for the origin of the overheating (blocked suction pipe, dirty 

fi

lter, etc.)

-   Clean the hose, empty the dust container and clean the 

fi

lters, if necessary.

-   Wait for about 30-40 minutes to allow the motor to cool down.

-   After 30-40 minutes, insert the plug in the mains socket and switch on the vacuum cleaner. 

The vacuum cleaner should now work.

-   If the vacuum cleaner still does not work, wait another 20 minutes and then try again.

-   If the cleaner still does not work, contact an Assistance Centre.