Toshiba Gigaframe Q-Series: Additional features (available on PA3650*-1ET2 only) Built-in battery
Additional features (available on PA3650*-1ET2 only) Built-in battery: Toshiba Gigaframe Q-Series
Table of contents
- Introduction Table of Contents
- Safety Instructions
- Follow the instructions below to install and operate the unit. Step 1: Check the components System Requirements:
- Controls on the front Controls on the back
- Step 2: Install the adjustable foot stand.
- Step 3: Connect the AC power.
- Step 4: (Optional) Insert a memory card.
- Step 5: Turn on the unit.
- Step 6: Operate the unit.
- Installing the changeable frame
- Using the Photo mode Using the Calendar mode
- Using the Music mode Using the Video mode
- Additional features (available on PA3650*-1ET2 only) Built-in battery
- Built-in tilt sensor Built-in light sensor
- Frequently asked questions
- TOSHIBA support Regulatory Information
- Working Environment
- Following information is only valid for EU-member states
- Disposal of batteries and/or accumulators
GMH300038010_EEU.book Page 14 Friday, June 20, 2008 12:18 AM
Gigaframe (PA3650*)
Additional features (available on PA3650*-1ET2
only)
Built-in battery
On the PA3650*-1ET2 model, the photo frame is equipped with a
built-in lithium polymer battery.
To charge the battery, follow the steps below:
1. Connect one end of the AC power adapter to the power jack on
the back of the photo frame.
2. Connect the other end to a power outlet.
3. Place the photo frame horizontally or vertically on a stable
surface, and then keep the power connected until the battery is
fully charged.
n When the battery charge is running out of power, a warning
message will appear on the screen. Charge the battery as
described above.
n The fully charged battery usually lasts about 30 minutes,
depending on your use and settings.
n Power system and plug types may vary depending on your
country/region.
Do not disassemble or modify the battery.
EN-14 User’s Manual
