Bang & Olufsen EarSet 2 - User Guide: instruction
Class: Headphones and Earphones
Type:
Manual for Bang & Olufsen EarSet 2 - User Guide
EarSet 2
Guide
Contents
3
English, 4
Dansk, 14
Svenska, 24
Suomi, 34
Deutsch, 44
Français, 54
Italiano, 64
Español, 74
Português, 84
Nederlands, 94
Русский, 104
Οδηγός, 114
4
English
Introducing EarSet 2
A
EarSet 2 is a headset equipped
with Bluetooth wireless
technology for hands-free call
handling via a mobile phone,
such as Serene, or other
C
C
B
products with Bluetooth
wireless technology.
D
Make and receive calls, transfer
E
calls to and from the mobile
phone, and charge the headset
in the enclosed charger. Place the
(A) … Ear hook. Tilt up and down
(D) … Indicator light. Shows the
lid on the charger and it
until the speaker fi ts your ear.
state of the headset.
becomes a practical carrying
(B) … Microphone arm. Rotate in
(E) … Ear pad. Put the ear pad on
case.
to switch the headset off, and
the speaker for greater listening
out to switch it on.
comfort.
Refer to the guide enclosed
(C) … Switch. Push up and down
with your mobile phone for
to adjust volume. Press or push
detailed information about
to answer an incoming call. Press
display messages, as these vary
and hold to redial the last dialled
from phone to phone.
number.
5
Indicator light on the headset
Sound feedback
The indicator light on the headset
Beep sounds inform you about the
(D) informs you about the current
state of the phone. The sounds and
state of the headset. The signals –
situations are described below.
which can only appear while the
One beep
headset is on – are explained below:
– Limit for speaker volume reached
Light off … No power. Charge the
– Call rejected
battery as described in ‘Charge
– Redial call started
the headset battery’.
Two beeps
Flashing green, slow … Ready for
– Call audio on in the headset
use.
(rising tone)
Flashing green, rapid … Incoming
– Call audio off in the headset
or active call.
(falling tone)
Flashing red, slow … Ready for use,
Repeating beep
but the battery requires charging.
– Battery low. Repeats three times
Flashing red, rapid … Indication
at thirty second intervals
during an incoming or active call
– Microphone muted. Repeats
that the battery requires charging.
continuously at 1.5 second
intervals
The indicator light flashes red when
there is less than five minutes of
talk time left.
6
>> English
Wear the headset
> Fold the microphone arm out as
shown. This switches on the
headset.
> Place the speaker in your ear,
adjusting the height and angle of
the ear hook as necessary. Make
sure that the microphone always
points towards your mouth. This
ensures the best sound quality.
EarSet 2 is intended for use in dry,
domestic environments only,
within a temperature range of
10–40ºC (50–104ºF).
Charge the headset battery
If the headset requires charging,
this occurs automatically when the
headset is placed in the charger.
About charging …
Indicator light on the charger
– The charger must be connected
The indicator light on the charger
to the power outlet.
(F) informs you about the current
– It takes approximately three
state of the charger.
hours to fully charge the battery.
Light off … Headset not connected
– The minimum talk-time per
to charger.
charge is approximately four
Steady red … Charging in progress.
hours.
Steady green … Charging
– Standby time per charge is
complete.
approximately 100 hours.
7
You can always place the headset
in the charger after use, even if the
battery does not need recharging.
Leaving the headset in the charger
does not reduce the lifetime of the
battery.
TIP: If you do not wish to use the
F
charger as a carrying case, you can
use the lid as a table stand. Place
the lid on the table with the top
side down and place the charger in
the lid.
WARNING! For use only with
the power supply included with
the product!
Manufacturer: Salcomp
ID-nummer: 8040017, 8040018,
8040020, 8040022, 8040023 or
8040024.
8
>> English
Register the headset to your
To register the headset …
Register the headset to a new
mobile phone
> Switch on the mobile phone.
mobile phone
To be able to use the headset, you
> If you are registering the headset
> Switch on the mobile phone. Do
must fi rst register it to a mobile
for the fi rst time, fold the
the next three steps in fi ve
phone with Bluetooth or to a
microphone arm out. This
seconds or less.
similar device with a hands-free
switches on the headset. The
> Press and hold the switch.
profi le.
indicator light fl ashes red and
> Fold the microphone arm out.
green.
> When the indicator light flashes
You can only register the headset
> Activate the search function on
red and green, release the
to one mobile phone or device at a
your mobile phone as described
switch.
time.
in the guide enclosed with the
> Activate the search function on
phone. When the mobile phone
your mobile phone as described
fi nds the headset, the headset is
in the guide enclosed with the
identifi ed as EarSet 2 in the
phone. When the mobile phone
mobile phone’s display.
fi nds the headset, the headset is
> If you are prompted for a
identifi ed as EarSet 2 in the
pincode by your mobile phone,
mobile phone’s display.
enter 0000. The headset is now
> If you are prompted for a
registered to the phone.
pincode by your mobile phone,
> If registration fails, switch off the
enter 0000. The headset is now
headset and repeat the
registered to the phone.
procedure.
> If registration fails, switch off the
headset and repeat the
procedure.
9
Make and answer calls
Answer a call …
To transfer calls between the
There are several ways to make calls.
When an incoming call is registered,
mobile phone and headset …
This depends on which mobile
the mobile phone and headset start
> To transfer a call from your mobile
phone you use. Refer to the guide
ringing.
phone to the headset, press the
enclosed with your mobile phone
> To answer the call, push or press
switch. A beep sounds from the
for further instruction.
the switch. A beep sounds from
headset when the call audio is
the headset when the call audio
connected.
Make sure that the headset is
is connected.
> To transfer a call from the head-
switched on. This is done by
> To reject an incoming call, press
set back to the phone, use the
folding the microphone arm out.
and hold the switch until a beep
mobile phone’s transfer function.
sounds in the headset.
Ways to make a call …
It is only possible to use Call Waiting,
– Make the call on your mobile
To end a call …
place calls on hold and switch
phone. With some models, the
There are several ways to end a call.
between calls on mobile phones
call audio is automatically
– Press the switch.
that support these services and
transferred to the headset. With
– Fold the microphone arm in.
functions.
others, you must transfer the call
– End the call manually on your
audio manually. A beep sounds
mobile phone.
from the headset when the audio
is transferred.
A beep sounds in the headset
– If your mobile phone or device
when the call is ended.
supports voice activated calls,
press the switch to activate the
When using the headset, make sure
function.
the mobile phone is no further than
– If your mobile phone or device
10 m (30 ft) from the head set.
supports redial, press and hold
the switch for at least 1.5
seconds to redial the last dialled
number.
10
>> English
Volume and the microphone
Adjust the headset ringer level
During calls, you can adjust the
During standby, you can adjust the
volume by pushing the switch up
headset ringer level by pushing the
or down. There are eight possible
switch up or down. There are eight
settings. When you reach the
possible settings. After each
upper or lower limit for sound
adjustment, the ringer melody is
volume, a beep sounds from the
played once.
headset.
The selected ringer level is used for
The selected volume level is used
all subsequent calls.
for all subsequent calls, but the
maximum volume setting that can
be stored is 6.
To switch the microphone off
during a call, press and hold the
switch until you hear a beep from
the headset. A repeating beep is
heard until the microphone is
switched back on.
To switch the microphone back on,
press or push the switch.
11
12 3
65 mm
2.56"
(1)
G
(2)
29 mm
29 mm
G
1.14"
1.14"
45 6
Mount the charger on the wall
If you choose, you can hang the
charger on a wall, using the charger
lid to mount the charger on the
enclosed wall bracket.
12
Waste Electrical and Electronic Equipment (WEEE) –
Environmental protection
The European Parliament and the
When disposing of electrical and
Council of the European Union
electronic equipment by use of the
have issued the Waste Electrical
collection systems available in your
and Electronic Equip ment Directive.
country, you protect the
The purpose of the Directive is the
environment, human health and
prevention of waste of electrical
contribute to the prudent and
and electronic equipment, and to
rational use of natural resources.
promote the reuse and recycling
Collecting electrical and electronic
and other forms of recovery of
equipment and waste prevents the
such waste. As such the Directive
potential contamination of nature
concerns producers, distributors
with the hazardous substances
and consumers.
which may be present in electrical
The WEEE directive requires that
and electronic products and
both manufacturers and end-
equipment.
consumers dispose of electrical
Your Bang & Olufsen retailer will
and electronic equipment and
assist with and advise you of the
parts in an environmentally safe
correct way of disposal in your
manner, and that equipment and
country.
waste are reused or recovered for
their materials or energy.
Electrical and electronic equipment
and parts must not be disposed of
with ordinary household refuse; all
electrical and electronic equipment
and parts must be collected and
disposed of separately.
Products and equipment which
must be collected for reuse,
recycling and other forms of
recovery are marked with the
pictogram shown.
13
This product fulfils the
conditions stated in the
EEU directives 89/336 and
73/23.
This product is CE marked
according to provisions of
the R&TTE Directive
(99/5/EC). Hereby, Bang &
Olufsen declares that this
product is in compliance
with the essential
requirements and other
relevant provisions of
Directive 1995/5/EC.
