Smeg KSET650X: INSTRUCTION ON MOUNTING AND USE

12

INSTRUCTION ON MOUNTING AND USE

GB

Cleaning

Replacing lamps - Fig. 4

Access the light compartment  according to the model

The cooker hood should be cleaned regularly internally and

in your possession, proceed as follows:

externally.

For cleaning use a cloth moistened with denatured alcohol

Warning!

or neutral liquid detergents. Avoid abrasive detergents.

Prior to touching the light bulbs ensure they are cooled down.

Warning:

Failure to carry out the basic standards of the cleaning of the

Model with halogen light bulbs.

cooker hood and replacement of the filters may cause fire

Use a small screwdriver to act as a lever on the border

risks.

of the light bulb housing in order to remove the light bulb.

Therefore we recommend oserving these instructions.

Replace the light bulb with a new PHILIPS STANDARD

Maintenance

LINE code 425409 12V 20W 30° Ø35 12V GU4.

Carry out the replacement and the mounting of the new

Prior to any maintenance operation ensure that the cooker

light bulb following the procedure in reverse.

hood is disconnected from the power supply.

Grease filter

Model with incandescent light bulbs:

This must be cleaned once a month (and, in the case of the

Remove the vapour screen.

model with electronic control panel, each time that the letter

Remove the grease filter, it will then be possible to

F alternated to the selected speed appears on the display

access the bulb housing area.

 see previous page) using non aggressive detergents,

Unscrew the damaged light bulb and replace it with a

either by hand or in the dish-washer, which must be set to

new 40W max (E14 - B35) light bulb.

a low temperature and a short cycle.

When washed in a dish-washer, the grease filter may

Model with PL light bulb.

discolour slightly, but this does not affect its filtering capacity.

Remove the vapour screen.

To remove the grease filter, pull the spring release handle

Remove the grease filter, it will then be possible to

(f) - (Fig. 2).

access the bulb housing area.

Only for model with electronic control panel:

Extract the damaged light bulb and replace it with a new

After washing the anti-grease filter, depress knob B (see

9W-G23 (Cooker hood with two light bulbs) or 11W-G23

preceding page) for about 3 seconds. The letter F will

(Cooker hood with one light bulb).

disappear from the display.

Charcoal filter (filter version only)

If the lights do not work, make sure that the lamps are

It absorbs unpleasant odours caused by cooking.

fitted properly into their housings before you call for

The carbon filter should be replaced every six months (and

technical assistance.

in cases of the model with the electronic control panel, each

Caution

time that the letter C appears on the display alternated

to the selected speed  see previous page).

This appliance is designed to be operated by adults. Children

1. Slide out the vapour collector.

should not be allowed to tamper with the controls or play with

2. Remove the grease filter.

the appliance.

3. If the carbon filter is already mounted and requires

Do not use the cooker hood where the grill is not correctly

replacement, depress the unblocking key (S - Fig. 10)

fixed! The suctioned air must not be conveyed in the same

and remove the filter downward.

channel used for fumes discharged by appliances powered

4. Remount the grease filter.

by other than electricity. The environment must always be

If the carbon filter is not mounted:

adequately aerated when the cooker hood and other

1. Slide out the vapour collector.

appliances powered by other than electricity are used at the

2. Remove the grease filter.

same time. Flambé cooking with a cooker hood is

3. Insert the carbon filter in the upper hooks T and fix it using

prohibited. The use of a free flame is damaging to the filters

the lower hooks S (Fig. 10).

and may cause fire accidents, therefore free flame cooking

4. Remount the grease filter.

must be avoided. Frying of foods must be kept under close

control in order to avoid overheated oil catching fire. Carry

Only for model with electronic control panel:

out fumes discharging in accordance with the regulations in

After replacing the charcoal filter, depress knob B (see

force by local laws for safety and technical restrictions.

preceding page) for about 3 seconds.

The letter C will disappear from the display.