HEIDENHAIN ND 2100G Quick Start: ND 2100 G GAGE-CHEK English Setup

ND 2100 G GAGE-CHEK English

Setup

For detailed description, see www.heidenhain.de

Before Power up

Controls and Displays

Connections side view

A LCD screen

8

Audio out, for 3,5 mm

Electrical connection

B

Soft keys change to support

headphone / speaker jack,

Line voltage: 100 V~ to 240 V~

functions.

monaural, 8 Ohm

(–15 % to +10 %)

C

Dimension keys display

9

USB Type A interface for printer

Line frequency: 47 Hz to 63 Hz

dimension values or graphs.

or data storage.

Line fuse: T1600 mA, 250 V

D

Command keys control

10

Remote accessory interface

5 x 20 mm

measurement activities.

RJ-45 for optional foot switch or

keypad accessory. Two optional

E

Arrow cursor keys for menu

Power connector wiring

remote accessories can be used

navigation.

simultaneously using an RJ-45

F

Numeric keypad for entering

splitter.

numeric data.

G

Fast track keys are

programmable for frequently

Mounting

used functions.

The ND 2100 G is secured to the

swivel slots of the mounting stand or

H

Send key transmits data to a PC,

arm mount by a shoulder screw, a cap

USB printer or USB drive.

screw mount is shown with associated

I

LCD on/off key turns the LCD on

washers.

or off or clears stored data.

L: Line voltage (brown)

Connections rear side

N: Neutral (blue)

1 Power switch

Earth ground (yellow/green)

2 Power connection with fuse

3

Ground (protective ground)

4

Encoder inputs are inputs for

Danger of electrical shock!

dimension formulas. The encoder

• Do not open the enclosure.

interface is specified at the time

• Never use 3-wire to 2-wire adapters

of purchase.

or allow the ground connection to

5

Relay outputs are two sets of

the ND 2100 G to be interrupted or

signalling relay contacts that

disconnected.

open and close under the control

of ND 2100 G formulas.

Caution

Changes to the power cable may be

Caution

made only by an electrical technician.

• Max contact voltage:

30 V

• Max contact switching current:

Caution

250 mA

Do not connect encoders or other

• Max contact carry current:

equipment to the ND 2100 G when the

500 mA

power is on.

• Contact rating:

3 Watts

• Static contact resistance:

Safety Considerations

0.20 Ohms

General accepted safety precautions

6

Parallel I/O port reads and

must be followed when operating the

writes standard TTL levels

ND 2100 G. Failure to observe these

under the control of ND 2100 G

Very important

precautions could result in damage to

formulas.

Please note

the equipment, or injury to personnel.

7

RS-232-C interface for PC

For your information

It is understood that safety rules within

connection. RS-232 cable must

individual companies vary. If a conflict

not include crossovers.

exists between the material contained

in this guide and the rules of a company

using this system, the more stringent

rules should take precedence.







 

 





1