Zanussi ZHC86540XA: Charcoal filter (filter version only) Operation Maintenance Replacing lamps Grease filter

Charcoal filter (filter version only)

Operation

Fig. 23

The hood is fitted with a control panel with aspiration speed

The charcoal filter can be washed once every two months

selection control and a light switch to control cooking area

using hot water and a suitable detergent, or in a dishwasher at

lights.

65°C (if the dishwasher is used, select the full cycle function

Use the high suction speed in cases of concentrated kitchen

and leave dishes out).

vapours. It is recommended that the cooker hood suction is

Eliminate excess water without damaging the filter, then put it

switched on for 5 minutes prior to cooking and to leave in

in the oven for 10 minutes at 100° C to dry completely.

operation during cooking and for another 15 minutes

Replace the mattress every 3 years and when the cloth is

approximately after terminating cooking.

damaged.

Maintenance

Replacing lamps

ATTENTION! Before performing any maintenance operation,

Fig. 25

isolate the hood from the electrical supply by switching off at

Disconnect the hood from the electricity.

the connector and removing the connector fuse.

Warning! Prior to touching the light bulbs ensure they are

Or if the appliance has been connected through a plug and

cooled down.

socket, then the plug must be removed from the socket.

Replace with a new 12 Volt, 20 Watt (Maximum) halogen light

The cooker hood should be cleaned regularly (at least with the

made for a G-4 base SUITABLE FOR USE IN OPEN

same frequency with which you carry out maintenance of the

LUMINAIRES. Follow package directions and do not touch

fat filters) internally and externally. Clean using the cloth

new light with bare hands.

dampened with neutral liquid detergent. Do not use abrasive

products. DO NOT USE ALCOHOL!

WARNING: Failure to carry out the basic cleaning

recommendations of the cooker hood and replacement of the

filters may cause fire risks.

Therefore, we recommend observing these instructions.

The manufacturer declines all responsibility for any damage to

the motor or any fire damage linked to inappropriate

maintenance or failure to observe the above safety

recommendations.

Fig. 22

This model is equipped with a perimetric suction panel.

The panel allows to optimize the performances of the

hood.

Attention! Hold the panel with both hands when

dismantling and re-mounting in position to avoid it falling

and causing damage to people or things.

Panel maintenance

Disassembly:

1. pull out firmly (LOWER SIDE) and rotate upwards.

2. unscrew the safety knob S

3. unhook it from the back hinges.

Cleaning:

The suction panel must be cleaned as frequently as the

grease filter, use a cloth dampened with neutral washing

liquids.

Avoid using products containing abrasives. DO NOT USE

ALCOHOL!

Assembly :

Operate inversely to disassembly.

Attention! always make sure that the panel is well fixed in its

proper place.

Grease filter

Fig. 9-24

The grease filter must be cleaned once a month using non

aggressive detergents, either by hand or in the dishwasher,

which must be set to a low temperature and a short cycle.

When washed in a dishwasher, the grease filter may discolour

slightly, but this does not affect its filtering capacity.

12