Fein SCT5-40M магазин: Overview.

9 01 04 007 01 0

9

en

Operating instructions for magazine holder.

Overview.

1 Screwdriver bit

Only use the special screwdriver bit.

2 Release knob

Press to remove the sliding piece dur-

ing maintenance work.

3 Grooved knob for adjusting the 

screwdriving depth

For altering the screwdriving depth of 

the screw in the material.

4 Screw stop

With grooved knob (a) for presetting 

to the length of screw used.

5 Screw strip

For mounting, fit the screw strip into 

the screw strip guide (b) and across 

the tooth points of the notched discs.

For your safety.

Before using this device, read and 

comply with:

these operating instructions,

the relevant national industrial safety 

regulations.

These operating instructions and the 

enclosed safety instructions should be 

kept carefully for later use and enclosed 

with the device, should it be passed on or 

sold.

Intended use.

This device is intended for:

commercial use in industry and trade,

as an accessory for FEIN screwdrivers.

especially for use in drywall construction 

using screw strips approved by FEIN.

To ensure that the device functions safely, 

only use screw strips that have been 

approved by FEIN.

Only FEIN magazine screwdrivers with a 

spindle collar diameter of 33 mm are suit-

able for driving the magazine holder.

Safety instructions.

Risk of injury

Please observe the operating instructions 

and safety instructions for the respective 

power tool used.

Do not point the device towards oneself 

or other persons once it is ready for use.

Only insert a new screw strip when the 

device is switched off.

Secure the work piece. A work piece that 

is gripped tightly in a clamping device or 

vice, is more secure than if held by hand.

Do not allow your fingers to enter the 

magazine holder or grasp the place to be 

screwed whilst working.

Personal protective equipment.

When using this device wear the follow-

ing protective items:

sturdy shoes, hair net (for long hair).

Handling.

➤

Insert a special screwdriver bit (1) into 

the tool holder of the screwdriver.

➤

Push the magazine holder onto the 

screwdriver bit and position it as far as 

the stop on the spindle collar of the 

drive machine.

!

3 41 01 083 06 0.book  Seite 9  Dienstag, 26. Februar 2008  3:02 15