PowerWalker AVR 600: instruction
Class: Equipment
Type:
Manual for PowerWalker AVR 600
Automatic Voltage Regulator (AVR)
PowerWalker AVR 1200
PowerWalker AVR 1000
PowerWalker AVR 600
Quick Start Guide
EN/DE/FR/ES/IT/PT/SE/FI/NO/TR
RU/UA/BY/PL/CZ/HR/HU/BG/KZ/CS/GR
1. Introduction
Thank you for purchasing PowerWalker product. This series is designed to automatically maintain a
constant voltage level to protect sensitive electronics from brownouts and overvoltages. With its
fashionable and flexible cabinet, it can be installed on a desk or wall without causing an unsightly or
unprofessional image, and will perfectly utilize a limited working environment. This series offers
one-step boost and one-step buck stabilizer to continuously supply a clean power source to its
connected equipment.
2. Product Overview
1. Output receptacles (for connected equipment)
2. AC Input 5. Power Switch
3. Circuit breaker 6. Power LED
4 .Modem/phone line surge protection 7. Boost/Buck LED
Wall Mount the Unit
The unit can be mounted to a wall surface. Please follow below steps:
1. Use tape to hold this page in place against the wall.
2. Use a sharp nail to puncture the center of the two holes to mark the wall.
(see below chart 1)
3. Mount the unit by positioning the key-hole slots over the mounting nails.
(see chart 2)
EN
3. Installation and Initial Startup
Inspection
Remove the unit from the shipping package and inspect it for damage that may occur during
transportation. Notify the carrier and place of purchase if any damage is found.
Placement & Storage Conditions
Install the unit in a protected area that is free of excessive dust and has adequate air flow. Please
place the AVR away from other units at least 2.5cm to avoid interference. Do NOT block the top or
side air vents on the unit.
Do not operation the unit in an environment where the ambient temperature or humidity is outside
the limits listed in the specifications. Operate the unit in an environment free of excessive dust,
mechanical vibration, inflammable gases and explosive or corrosive atmospheres.
Connect to the Wall Outlet
Plug the input power cord of the unit to the wall outlet.
Connect the Loads
ill be powered.
Connect Modem/Phone for Surge Protection (Only for the model with RJ-11)
Connect a single modem/phone line into surge-
Turn On/Off the Unit
used as the master ON/OFF switch for all connected devices.
EN
