Caravell Slimline SLC 168: Caravell Slimline

Caravell Slimline

ENGLISH

7

• Keep the cover open or remove the sliding covers and place

If the cabinet is very hot or air circulation is poor, you should

them carefully on the floor.

provide the necessary circulation.

If the condenser is dirty, it should be vacuum-cleaned.

• Remove the ice layer using plastic or wooden implements

(never use metal implements).

If you have checked the above and the freezer is still not working,

call a service engineer.

• The de-icing process can also be speeded up by using bowls

State the type of fault and appliance, serial number and item no.

of hot water.

(shown on the manufacturer’s plate on the back of the cabinet).

• Never use pointed or sharp implements.

8 Disposal

• After de-icing, clean the cabinet as described under Section

6. Dry thoroughly after cleaning.

The owner of the freezer is responsible for disposing of the freezer

in a responsible way in accordance with the relevant legislation.

6 Maintenance

When a life-expired freezer is to be disposed of, it should be

disposed of in an environmentally friendly and responsible

Please note the following in connection with cleaning of the

manner.

freezer:

Be aware of the rules for disposal. There may be special

• Place the products from the freezer in a cold place or wrap

regulations which must be followed.

them in insulating material.

You can obtain information on disposal from:

• The cabinet should be switched off at the socket.

• Your dealer

• Keep the cover open or remove the sliding covers and place

• The relevant authorities (municipal authority, environmental

them carefully on the floor.

protection agency or other similar body)

The freezer can be cleaned with luke warm water and mild

• WEEE marking.

detergent. It should then be washed with clean water.

Never use detergents which contain chlorine.

Handling of life-expired electrical and electronic products. (Applies

to the European Union and other European countries with

Never use pointed or sharp implements.

separate collection systems.)

Clean the cover in the same way as the cabinet. If the freezer is

fitted with a condenser and associated fan at the bottom rear of

9 Special considerations

cabinet, dirt and dust can collect on the cooling element. If

cleaning is necessary, the power should be switched off, the cover

The information in this user manual was correct at the time of

removed and the cooling element vacuum-cleaned with a soft

printing.

brush.

Due to our programme of continuous product development, we

Remove the cover as follows. Remove all screws holding the

must however reserve the right to make technical changes to the

cover in place and put to one side. Carefully draw the cover out as

freezer models concerned. We will of course strive to continually

far as possible (taking care not to damage the thermostat’s sensor

update the user manual.

cable). It will now be possible to access the cooling element with

You should contact your dealer if you are in any doubt concerning

the vacuum cleaner brush.

the correct use of the freezer. They will be able to advise you on

Be aware that the cooling element consists of sharp

this.

components and may be hot to touch.

The manufacturer accepts no liability for accidents or

After cleaning, refit the cover and insert and tighten all screws.

complications caused by the incorrect connection of the

equipment.

7 Troubleshooting

10 Guarantee

If you experience any problems with your freezer, please check

the following before seeking assistance:

Any guarantee will be void if the product has been misused!

• Is the plug inserted?

This means used for purposes other than that originally intended,

failure to follow the instructions in this manual and transport of the

• Is the socket switched on?

product not in its original packaging.

If changes are made to the freezer by unauthorised personnel, the

• Is the fuse in the meter cabinet intact?

manufacturer accepts no liability in connection with material

• Has any fault current relay been disconnected?

damage and/or personal injury.

• Has there been a complete power failure?

Caravell Slimline

ENGLISH

8

In your own interests, you should always use factory-authorised

personnel in connection with all forms of modification, repair or

servicing.

The manufacturer reserves the right to make changes to

specifications without prior notice and without any undertaking

concerning spare parts availability.