Scarlett SC-4142: GB INSTRUCTION MANUAL IMPORTANT SAFEGUARDS FOOD PROCESSOR ASSEMBLING FOOD PROCESSOR USING CLEANING AND CARE STORAGE

GB INSTRUCTION MANUAL

IMPORTANT SAFEGUARDS

• Before the first connecting of the appliance check that voltage indicated on the rating label corresponds to the mains

voltage in your home.

• For home use only. Do not use for industrial purposes. Do not use the appliance for any other purposes than

described in this instruction manual.

• Do not use outdoors.

• Always unplug the appliance from the power supply before cleaning and when not in use.

• To prevent risk of electric shock and fire, do not immerse the appliance in water or in any other liquids.

• Close supervision is necessary when it is used near children.

• Do not leave the appliance switched on when not in use.

• Do not use other attachments than those supplied.

• Do not operate after malfunction or cord damage.

• Do not attempt to repair, adjust or replace parts in the appliance. Check and repair the malfunctioning appliance in

the nearest service center only.

• Keep the cord away from sharp edges and hot surfaces.

• Do not pull, twist, or wrap the power cord around appliance.

• Never attempt to take food or liquid out from the container when the blade is moving. Always wait until the motor

stops completely.

• Do not overload the appliance with food.

• The appliance operates fast and effective. Do not operate continuously for more than 3 min.

• Never place hot ingredients into processor (> 70 ºC).

FOOD PROCESSOR ASSEMBLING

• Before the first using, wash all removable parts in warm soapy water, rinse thoroughly and dry. Wipe the housing

with a damp cloth.

• Never immerse motor body in any liquid or wash under running water.

• Place the motor unit on a level surface.

NOTE: you must complete assembling fully; otherwise you cannot switch on device.

FOOD PROCESSOR USING

CAUTION: Do not operate continuously longer than 3 minutes with less than 1 minute intermission.

• Do not overload the appliance by putting in too much food and do not operate continuously for more than one

minute.

• Do not remove any parts during the operating.

• Place the blender jug onto the blender gear. Make sure it properly fitted.

• Put ingredients into blender jug, and close it with the lid.

• Insert beaker into the lid and then put the lid onto the blender jug. Make sure all parts securely fitted.

• Plug-in, turn the switch/press buttons to recommended speed:

– "1"(low speed) – for liquid ingredients mainly.

– "2" (high speed)– for heavier processing, i.e. liquid and solid ingredients mixtures.

– The appliance will operate until it will be switched off.

– “PULSE” – pulse mode.

CAUTIONS:

– Avoid operating the empty blender;

– Never place hot ingredients into blender jug (> 70 ºC);

– Ingredients must be cut into small pieces before processing in blender jug;

– Never fill blender jug with a liquid over maximum level marked;

• When processing is finished, switch off, and then unplug the appliance and wait the motor will stop before

removing food and attachments.

CLEANING AND CARE

• Switch off and unplug the appliance.

• Wash the accessories immediately and avoid soaking them in water for long periods; wash in warm soapy water

after each use. Dry all accessories with a clean soft cloth.

• Wipe housing with a damp cloth.

• Do not use scouring pads, abrasive and harsh detergents.

CLEANING THE BLENDER JUG

• Place empty blender jug onto the motor unit and cover with the lid.

• Pour a little warm soapy water into the blender jug, and switch on PULSE mode for a few seconds.

•

Remove the blender jug; rinse it under running water and dry.

• DO NOT IMMERSE THE MOTOR UNIT IN ANY LIQUID OR IN A DISHWASHER.

CAUTION: The blades are extremely sharp and therefore dangerous. Handle with caution!

STORAGE

• Be sure that the appliance is unplugged.

• Complete all requirements of Chapter CLEANING AND CARE.

Keep the appliance in a dry clean place.

www.scarlett-europe.com SC-4142

4