Saturn ST-HC7381: HAIR CLIPPER Description PREPARING FOR USE REPLACING THE CUTTING HEAD

GB

appliance, it should be placed in the

HAIR CLIPPER

battery charging stand 4, so that the

control lamp 5 lights up. While the ap-

Dear Buyer!

pliance is being charged, the switch

We congratulate you on having

must be set at "0" ("0" must be visible).

bought the device under trade name

A charging period of 16 hours is re-

«Saturn». We are sure that our de-

quired before initial use. Take care to

vices will become faithful and relia-

keep the charging contacts 3 clean, as

ble assistance in your housekeep-

soiled charging contacts can interfere

ing.

with the charging process. Overcharging

Avoid extreme temperature chang-

of the appliance is not possible.

es. Rapid temperature change (e.g.

3. After charging the appliance is

when the unit is moved from freez-

ready for use. It can be used with or

ing temperature to a warm room)

without the clip-on comb attachment. To

may cause condensation inside the

attach the clip-on comb attachment,

unit and a malfunction when it is

slide it onto the cutting head 1 until it

switched on. In this case leave the

clicks into position. The appliance must

unit at room temperature for at

be switched off while the clip-on comb

least 1.5 hours before switching it

attachment is being attached or re-

on.If the unit has been in transit,

moved.

leave it indoors for at least 1.5

4. The clip-on comb attachment is

hours before starting operation.

easily adjustable. Simply slide it up or

down the cutting head 1. The hair can

be cut to 4 different lengths ranging

Description

from approximately 3 mm to 6 mm. The

position of the clip-on comb attachment

on the cutting head determines the

length of the haircut.

5.

After using the appliance, switch it

off and replace it in the battery charging

stand 4 to be recharged the control

lamp 5 must light up. In order to retain

the load capacity of the storage battery

we recommend to use the storage bat-

tery until it is empty before reloading

.

1. Cutting head

2. On/off switch

3. Charging contacts

4. Charging stand

5. Control lamp

6. Clip-on comb attachment

PREPARING FOR USE

1. The appliance as supplied by the

manufacturer is not yet ready for use.

Figure 1

It must be electrically charged prior

to use.

REPLACING THE CUTTING HEAD

2. Insert the plug of the battery

Switch the appliance off before re-

charging stand 4 into a socket. Warn-

placing the cutting head!

ing! This appliance must be charged at

If the performance of the appliance de-

the specified voltage! You can store the

teriorates after extended use, despite

remainder the charging stand 4 (220-

regular cleaning and maintenance, the

230V, 50Hz). In order to charge the

2 3