Vitek VT-3549 SR: ENGLISH

ENGLISH

around 45 seconds intervals. The main unit will also start searching for signals for

about two minutes once batteries are installed. 10 seconds upon successful reception,

the outdoors temperatures and humidity will be displayed .The main unit will automati-

cally update its readings at about 45-second intervals.

b. If no signals are received, blanks “--.-” will be displayed.

Hold [-] for 2 seconds to enforce another search for about 2 minutes. This is useful in

synchronizing the transmission and reception of the remote and main units.

c. When remote signal reception is finished, it will automatically synchronize its current

time and dated when brought within rang of the signal.

Repeat this step whenever you find discrepancies between the reading shown on the

main unit and that on the remote unit.

HOW TO CHECK REMOTE AND INDOOR TEMPERATURES

The wave display on the outdoors temperature indicates the reception of the remote

unit is in good order.

If no readings are received from the remote unit for more than two minutes, blanks “--

.-” will be displayed until further readings are successfully searched. Check the remote

unit is sound and secure. You can wait for a little while or Hold [-] for 2 seconds to

enforce an immediate search.

If the temperature or humidity goes above or below than the measuring range of the

main unit or the remote unit (stated in specification), the display will show “--.-” &

“HHH” or “LLL” respectively.

HOW TO READ THE KINETIC WAVE DISPLAY

The kinetic wave display shows the signal receiving status of the main unit. There are

three possible forms:

The unit is in searching mode.

Temperature readings are securely registered.

No signals.

MAXIMUM AND MINIMUM TEMPERATURES AND HUMIDITY

The maximum and minimum recorded indoor temperature, humidity and outdoor tem-

peratures will be automatically stored in memory. To display them, Press [MEM] once

to display the maximum readings and again the minimum readings.

The respective indicators [MAX] or [ MIN ] will be displayed.

To clear the memory, hold down [MEM] for two seconds.

The maximum and minimum readings will be erased.

6

3549.indd 649.indd 6 02.06.2006 16:59:3602.06.2006 16:59:36