Saturn ST-HT7265: Usage: Usage Guidance Components: Brief Introduction of the product: Assemble before you use: Electric Drawing:

GB

CONVECTION HEATER

Dear Buyer!

We congratulate you on

having bought the device

under trade name «Saturn».

We are sure that our devices

will become safe and reliable

assistance in your

Usage:

housekeeping.

4. Please check before you use:

Avoid extreme temperature

A: The heating wire and electric

changes. Rapid temperature

wire cannot be broken.

change (e.g. when the unit is

B: Please do not use the socket

moved from freezing

lower than 10A for fear of any

temperature to a warm room)

accident.

may cause condensation

5. Use the convector on the flat

inside the unit and a

place to avoid being toppled.

malfunction when it is

6. There are 2 switches for the

switched on. In this case

power setting. I - for 800W, II -

leave the unit at room

for 1200W. You can get 3 power

temperature for at least 1.5

setting 800W, 1200W, 2000W

hours before switching it on.

(800W+1200W).

If the unit has been in

4. There is a thermostat knob for

transit, leave it indoors for at

adjusting heating. You can rotate

least 1.5 hours before

the knob to get your desired

starting operation.

heating level.

5. If you stop using convector,

turn off all the power switch, and

Before operating this unit, please

then, put off the plug.

read these instructions carefully

6. If you want to move the

convector, please turn off the

switches, then, put off the plug,

and hand on the handle on the

Usage Guidance

back of the convector.

· Please read this guidance

carefully before using the

Components:

electrical appliance, so that

you can use it correctly.

· Please keep this guidance

well.

Brief Introduction of the

product:

The convector adopts convecting

heating technology, and has a

high heating efficiency,

centralized heat and adjustable

heating range.

The convector has a reasonable

foot structure not easy to be

toppled by accident.

Assemble before you use:

Please assemble the feet and the

Electric Drawing:

body in the order given on the

picture below:

1. Place the convector on the flat

desk or carton.

2. Insert 4 position pins of the

feet into the position holes of the

body.

3. Tight the fixed screw to

connect body and feet.