Главная > Инструкция к Ноутбуку Dell Latitude XT2 > Heat Sink and Fan Assembly

Dell Latitude XT2: Heat Sink and Fan Assembly

Heat Sink and Fan Assembly : Dell Latitude XT2

Heat Sink and Fan Assembly

Dell™Latitude™XT2ServiceManual

Removing the Heat Sink and Fan Assembly

1. Follow the procedures in Before Working Inside Your Tablet-PC.

2. Remove the battery from the Tablet-PC.

3. Remove the hard drive from the Tablet-PC.

4. Remove the memory and mini-card cover from the Tablet-PC.

5. Remove the memory from the Tablet-PC.

6. Remove the mini-card from the Tablet-PC.

7. Remove the BIOS chip from the Tablet-PC.

8. Remove the Bluetooth module from the Tablet-PC.

9. Remove the hinge cover from the Tablet-PC.

10. Remove the keyboard from the Tablet-PC.

11. Remove the display assembly from the Tablet-PC.

12. Remove the palm rest from the Tablet-PC.

13. Remove the system board from the Tablet-PC.

14. Disconnect the fan cable from the system board connector, then flip over the system board.

15. Loosen the four captive screws on the heat sink.

WARNING: Before working inside your Tablet-PC, read the safety information that shipped with your Tablet-PC. For additional safety best

practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

16. Remove the top section of the heat sink assembly from the system board, then turn over the system board again.

17. Remove the bottom section of the heat sink assembly.

Оглавление

Топ 10 инструкций

Другие инструкции

Dell Precision M20 Dell Precision M20 Dell Latitude XT3 Dell Latitude XT3 Dell Latitude XT Dell Latitude XT Dell Latitude X300 Dell Latitude X300